|
XS
Scuba Poppet
Align/Preset Tool
The XS Scuba Poppet
Align/Preset Tool is
designed as a dual
function tool. One end
is used to preset the
depth of the orifice in
the air barrel, and the
opposite end is used to
control the poppet
orientation when it is
installed into the air
barrel. The orifice is
installed and preset to
the approximate depth
first. After inserting
the orifice into the air
barrel, engage the drive
bit with the orifice
slot and thread the
orifice into the air
barrel as far as it will
go. This will position
the orifice at a depth
of .480” - .490”.
With the orifice
positioned, turn the
tool around and insert
the poppet into the
notched end of the tool.
Orientate the poppet and
tool, as shown in the
illustration to the
right, and slide it into
the air barrel as far as
it will go. Install the
lever into the air
barrel. Press inward on
the lever tabs to hold
the poppet in place
while the tool is
removed. Shipped with
complete instructions.
|
|
XS Scuba Poppet Align/Preset Tool |
|
SI-20785400
$16.50 |
|
|
|
XS
Scuba Rim Clamp
The XS Scuba Rim Clamp
is machined to fit the
XS Scuba Sea Air®,
Spirit®, and Air Wave®
second stages. It is
designed to assist the
technician in removing
second stage diaphragm
retaining rims that can
not be normally removed
by hand.
The internal ledges are
sized to fit the rims
exactly, to prevent rim
distortion during
removal. After the rim
has been installed into
the clamp, the clamp can
be "squeezed gently" in
a bench vise to keep the
rim from slipping while
it is removed by turning
the second stage
housing.
The XS Scuba Rim Clamp
will fit both the metal
and plastic rims.
Natural aluminum finish.
|
|
XS Scuba Rim Clamp |
|
SI-20790200
$23.00 |
|
|
|
